PCB Forsegling | TWO Teknik

Are you looking for the best PCB sealant?

TWO/SPS is the only sealer that does not require an Epoxy course!

  • Create MAL code.
  • No harmful substances
  • Only 30 minutes waiting time between each layer.
  • Cures already at +1 degree
  • Only 24 hours of curing time

Why choose PCB sealant from TWO Teknik?

  • SPS Primary and Primary Winter are the products on the market that take the greatest consideration for both the environment and the craftsman.
  • SPS Primær and Primær Vinter are effective, easy and quick to work with.
  • SPS Primer and Primer Winter are developed to seal PCB and designed to be a part of an optimized construction project where efficiency, time, and the environment are all important factors.
  • RUC and Danish Environmental Analysis have documented the effectiveness of SPS Primary and Primary Winter.

The easiest and best solution against PCBs

If you need to seal PCB in your work task, you should choose SPS products from TWO TEKNIK. Our PCB sealers are the only approved products that do not require an epoxy course. You can work nearby without protection because SPS products do not contain harmful and dangerous substances.

We have supplied PCB encapsulation to leading demolition contractors, contractors, and consultants for more than 10 years. Our encapsulation product has been used in all conceivable PCB renovations throughout the country.

We are constantly developing SPS Primær and SPS Primær Vinter, and continuously optimizing our products. The effectiveness of our PCB sealer has been documented by Roskilde University Center (RUC) and Danish Environmental Analysis.

The advantages of SPS Primary - sealing

Hardens in just 24 hours. Only 30 minutes waiting time between each layer.

Adheres to all surfaces. Used in Danish construction for more than 10 years.

Does not require Epoxy-course Contains no harmful substances

Questions and answers

We are constantly developing and optimizing our products. Our first sealing product took 2 years to develop.

RUC and Danish Environmental Analysis have documented the effectiveness of our sealers.

You should choose our PCB sealer because our product is the only approved Danish product on the market that does not require an Epoxy course.

You get a product that is specifically developed to seal PCB and designed to be part of an optimized building project, where both efficiency, time, and environmental considerations are important.

0